Product Description
Size: o5.5( ※for Motorcycle of Less than 125cc)
[Specifications]
Insertion Part Inner Diameter: o3.1
Insertion Part Outer Diameter: o5.5
Maximum Diameter: o29.0
Length: 41.0mm
Corresponding Hose Inner Diameter: o5.0-5.5
Filter was installed in the middle of Fuel hose from Fuel Tank.
Dirt condition can be checked immediately by making it transparent Body.
Hose Measure the inner diameter and select the one fitted with the dimensions of the Filter side insertion part.
Large The size and shape are various, it is selected by considering the installation space.In addition, filter material and filtration method are various, it is necessary to consider Gasoline flow rate etc. necessary for the own vehicle. (Especially Big bike, 2Cycle cars are noted)
Since the importance is placed on the flow rate, the filtration ability is lower than PaperType.
Durability is higher than fiber Mesh.
* Overall length is the total length including plug-ins.
* Hose diameter is only indication of use.
[Note]
* Non-disassembly type filters must be replaced when they get blocked with dirt. If left without inspection, the circuit may clog with dirt and cause insufficient petrol flow. Be sure to check it on a regular basis and consider the angle when mounting to avoid such situation.
* Cannot be used for large-diameter carburetors such as FCR, etc. It will cause inadequate amount of petrol supply to the cabulator.
* This product is plastic therefore is not heat-resistant. Install where it won't be affected by the heat of the engine, etc. Deformation caused by heat may occur.